TL-0005 — Curing Compounds and Form Release Agents Technical Letter (US Version)
Curing compounds used on any concrete to be waterproofed with BITUTHENE® membrane or PROCOR® membrane must not contain wax, oil, silicone or pigment. Some curing compounds require a dissipation period for breakdown to occur through UV exposure and construction traffic. This can range typically from four to eight weeks and may impact the adhesion of BITUTHENE® or PROCOR® membranes if not allowed to fully dissipate. Cleaning or removal of the curing compound may be required prior to waterproofing membrane installation and should be done following the curing compound manufacturer’s recommendations.
Acceptable types of curing compounds include:
- Petroleum resin
- Chlorinated rubber
- Styrene butadiene
Sometimes surface hardeners may be referred to as curing compounds. Common surface hardeners include:
- Sodium silicate
- Zinc or magnesium fluorosilicate
BITUTHENE® waterproofing membrane may be used over these materials.
Form Release Agents
All non-transferring commercial form release agents, when applied in accordance with the manufacturer’s instructions, are acceptable. Diesel fuel or other types of petroleum oils can adversely impact adhesion of BITUTHENE® and PROCOR® membranes if transferred to the concrete.
A test application or job mock-up would be recommended to ensure compatibility.
gcpat.com | North America Customer Service: 1 877-4AD-MIX1 (1 877-423-6491)
We hope the information here will be helpful. It is based on data and knowledge considered to be true and accurate, and is offered for consideration, investigation and verification by the end user, but we do not warrant the results to be obtained. Please read all statements, recommendations, and suggestions in conjunction with out conditions of sale, which apply to all goods supplied by us. No statement, recommendation, or suggestion is intended for any use that would infringe any patent, copyright, or other third party right.
BITUTHENE and PROCOR are trademarks, which may be registered in the United States and/or other countries, of GCP Applied Technologies Inc. This trademark list has been complied using available published information as of the publication date and may not accurately reflect current trademark ownership or status.
© Copyright 2019 GCP Applied Technologies Inc. All rights reserved.
GCP Applied Technologies Inc., 62 Whittemore Avenue, Cambridge, MA 02140 USA.
This document is only current as of the last updated date stated below and is valid only for use in the United States. It is important that you always refer to the currently available information at the URL below to provide the most current product information at the time of use. Additional literature such as Contractor Manuals, Technical Bulletins, Detail Drawings and detailing recommendations and other relevant documents are also available on www.gcpat.com. Information found on other websites must not be relied upon, as they may not be up-to-date or applicable to the conditions in your location and we do not accept any responsibility for their content. If there are any conflicts or if you need more information, please contact GCP Customer Service.
Last Updated: 2021-02-09